48
Chapter 7: Configuring the Wireless-G Access Point
The Wireless - Wireless MAC Filter Tab
Wireless-G Access Point
The Wireless - Wireless MAC Filter Tab
This screen allows you to permit or block wireless access for computers with specific MAC addresses.
Wireless MAC Filter
Access Restriction
If you want to control access to your wireless network, select Enable. If you do not wish to filter users by MAC
address, select Disable.
To deny access, click Prevent PCs listed below from accessing the wireless network. To permit access, click
Permit PCs listed below to access the wireless network.
MAC 01-25. Enter the MAC addresses of the computers whose access you want to control. If you want to list
more than 25 MAC addresses, then select MAC Addresses 26~50 from the drop-down menu.
Click Clear to delete the MAC addresses you have entered.
Change these settings as described here and click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. Click Help for more information.
Figure 7-19: Wireless - Wireless MAC Filter Screen
mac address: the unique address that a manufacturer
assigns to each networking device.
To Next Page
Loading...
