15
Chapter 5: Setting up the Wireless-G Access Point
Using the Setup Wizard
Wireless-G Access Point
2. Press the Access Point’s orange Cisco logo on its front panel. When the logo turns white and begins to flash,
press the SecureEasySetup button on another device. The Access Point’s Cisco logo will stop flashing when
the device has been added to the network. Then repeat this procedure for each additional SecureEasySetup
device.
When you have finished configuring the devices in your wireless network, click the Next button to continue.
3. The Setup Wizard will ask you to review your settings before it saves them.
Click the Yes button if you are satisfied with your settings, or click the No button if you do not want to save
your new settings.
Figure 5-14: Configure Wireless Settings Screen
Figure 5-15: Confirm New Settings Screen
NOTE: You can only add one SecureEasySetup device at a time.
NOTE: Write down these settings. You may need to manually configure non-SecureEasySetup
devices in the future.
To Next Page
Loading...
