EasyManuals Logo

Linksys WIRELESS-G WRT54GS User Manual

Linksys WIRELESS-G WRT54GS
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
17
Chapter 5: Configuring the Wireless-G Broadband Router
The Setup Tab - Basic Setup
Wireless-G Broadband Router with SpeedBooster
Optional Settings
Some of these settings may be required by your ISP. Verify with your ISP before making any changes.
Router Name. In this field, you can type a name of up to 39 characters to represent the Router.
Host Name/Domain Name. These fields allow you to supply a host and domain name for the Router. Some ISPs,
usually cable ISPs, require these names as identification. You may have to check with your ISP to see if your
broadband Internet service has been configured with a host and domain name. In most cases, leaving these
fields blank will work.
MTU. MTU is the Maximum Transmission Unit. It specifies the largest packet size permitted for Internet
transmission. You should leave this value in the 1200 to 1500 range. To have the Router select the best MTU for
your Internet connection, select Auto. The default setting is Auto.
Network Setup
The Network Setup section changes the settings on the network connected to the Router’s Ethernet ports.
Wireless Setup is performed through the Wireless tab.
Router IP
This presents both the Router’s IP Address and Subnet Mask as seen by your network.
Network Address Server Settings (DHCP)
The settings allow you to configure the Router’s Dynamic Host Configuration Protocol (DHCP) server function. The
Router can be used as a DHCP server for your network. A DHCP server automatically assigns an IP address to
each computer on your network. If you choose to enable the Router’s DHCP server option, you must configure all
of your network PCs to connect to a DHCP server (the Router), and make sure there is no other DHCP server on
your network.
DHCP Server. DHCP is enabled by factory default. If you already have a DHCP server on your network, or you
don’t want a DHCP server, then click the Disable radio button (no other DHCP features will be available).
Starting IP Address. Enter a value for the DHCP server to start with when issuing IP addresses. Because the
Router’s default IP address is 192.168.1.1, the Starting IP Address must be 192.168.1.2 or greater, but smaller
than 192.168.1.253. The default Starting IP Address is 192.168.1.100.
Maximum Number of DHCP Users. Enter the maximum number of PCs that you want the DHCP server to assign
IP addresses to. This number cannot be greater than 253. The default is 50.
Figure 5-11: Network Address Server Settings
Figure 5-10: Router IP
Figure 5-9: Optional Settings

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys WIRELESS-G WRT54GS and is the answer not in the manual?

Linksys WIRELESS-G WRT54GS Specifications

General IconGeneral
Wireless Standard802.11g
Frequency Band2.4 GHz
Ethernet Ports4x 10/100 Mbps LAN, 1x 10/100 Mbps WAN
Security FeaturesWEP, WPA, WPA2, SPI Firewall
Data Transfer Rate54 Mbps
ButtonsReset, SecureEasySetup
Operating Temperature32 to 104°F (0 to 40°C)
Storage Temperature-4 to 158°F (-20 to 70°C)
Operating Humidity10% to 85% Non-condensing
Storage Humidity5% to 90% Non-condensing
Antenna2 x External
LEDsPower, DMZ, WLAN, LAN (1-4)
Power12V DC

Related product manuals