101
Appendix F: Finding the MAC Address and IP Address for your Ethernet Adapter
Windows 2000 or XP Instructions
Wireless-G VPN Router with RangeBooster
Windows 2000 or XP Instructions
1. Click Start and Run. In the Open field, enter cmd. Press the Enter key or click the OK button.
2. At the command prompt, enter ipconfig /all. Then press the Enter key.
3. Write down the Physical Address as shown on your computer screen; it is the MAC address for your Ethernet
adapter. This appears as a series of numbers and letters.
The MAC address/Physical Address is what you will use for MAC address cloning or MAC filtering.
On the MAC Address/Physical Address screen, the example shows the Ethernet adapter’s IP address as
192.168.1.100. Your computer may show something different.
Figure F-3: MAC Address/Physical Address
Note: The MAC address is also called the Physical Address.
To Next Page
Loading...
