9
Chapter 4: Getting to Know the Wireless-G VPN Router
The Back Panel
Wireless-G VPN Router with RangeBooster
Chapter 4: Getting to Know the Wireless-G VPN Router
The Back Panel
The Router’s ports, where a network cable is connected, are located on the back panel.
Power The Power port is where you will connect the power adapter.
Reset Button There are two ways to reset the Router's factory defaults. Either press the Reset Button, for
approximately five seconds, or restore the defaults from the Administration tab - Factory
Defaults in the Router's Web-based Utility.
Ethernet (1-4) The Ethernet ports connect to your PCs and other network devices.
Internet The Internet port connects to your cable or DSL modem.
IMPORTANT: If you reset the Router, all of
your settings, including Internet connection,
wireless, and security, will be deleted and
replaced with the factory defaults. Do not
reset the Router if you want to retain these
settings.
Figure 4-1: Back Panel
To Next Page
Loading...
