38
Chapter 6: Configuring the Wireless-G VPN Router
The Firewall Tab - URL Filtering
Wireless-G VPN Router with RangeBooster
To modify a service, select it from the list on the right. Change its name, protocol setting, or port range. Then
click the Modify button.
To delete a service, select it from the list on the right. Then click the Delete button.
When you are finished making changes on the Port Services screen, click the Apply button to save changes.
If you want to cancel your changes, click the Cancel button. To close the Port Services screen and return to
the Access Restrictions screen, click the Close button.
The Firewall Tab - URL Filtering
To create an URL Filtering policy:
1. Select a number from the URL Filtering Policy drop-down menu.
2. Enter a Policy Name in the field provided.
3. To enable this policy, select Enabled from the Status menu.
4. Enter the Start IP Address and End IP Address what will be affected by the policy. After making your changes,
click the Save Settings button to apply your changes.
5. The address entered to access Internet site, by entering the address in the URL String field.
6. Click the Save Settings button to save the policy’s settings. To cancel the policy’s settings, click the Cancel
Changes button.
When you have finished making changes to the screen, click the Save Settings button to save the changes, or
click the Cancel Changes button to undo your changes. Help information is shown on the right-hand side of a
screen. For additional information, click More.
Figure 6-32: The Firewall Tab - URL Filtering
To Next Page
Loading...
