3.
In the
Internet Setup > Internet Connection Type
section select either PPPoE, or
IPoE (dynamic or static IP address) as required by your ISP (check with your
provider’s helpdesk if you’re not sure). Select Bridge Mode only to use the unit as a
modem without router functionality (i.e., without Wi-Fi or any other network
functions).
• If using PPPoE, enter the correct username and password as specified by
your ISP.
•
If your connection type is Dynamic, select
IPoE
for
Internet Connection
Type
, and for IP Settings select
Automatically obtain an IP address
.
•
If your ISP requires IPoE with a static IP address, select
IPoE
for
Internet
Connection Type
, then select
Use the Following IP Address
and enter the IP
address settings (given to you by your ISP) in the fields provided.
4.
Click Save Settings (at the bottom of the page) to save settings and complete
setup.
10
To Next Page
Loading...
