Wi-Fi Protected Setup
Three methods of Wi-Fi Protected Setup are available. Use the method that applies to the
client device you are configuring.
Note--Wi-Fi Protected Setup configures one client device at a time . Repeat the
instructions for each client device that supports Wi-Fi Protected Setup.
Wi-Fi Protected Setup light activity
•
The logo on the top panel of the router functions as the Wi-Fi Protected Setup
light.
•
When the Wi-Fi Protected Setup process is active, the light flashes slowly. When
the Wi-Fi Protected Setup is successful, the light is continuously lit.
•
If there is an error, the light flashes quickly for two minutes; please wait and try
again.
•
Wait until the light is continuously lit, before starting the next Wi-Fi Protected
Setup session.
Wi-Fi Protected Setup Button
Use this method if your client device has a Wi-Fi Protected Setup button.
Note—Make sure you configure one client device at a time.
1.
Click or press the Wi-Fi Protected Setup button on the client device.
21
To Next Page
Loading...
