Page 5 of 19 FA69386–2 English
Jun 2013
19
How To Use the Communications
Options
Linx 5900 & 7900
2.1.2 Configure the Ethernet Protocol
NOTE: To use the Ethernet Protocol option, the RS232 Protocol option must be set to
‘RPC’. Only the RCI protocol is available through an Ethernet connection.
To use the Ethernet protocol for remote network communications:
1 Select the Ethernet Protocol option on the Protocol page to display the Ethernet
Protocol page.
Figure 4. Ethernet Protocol page
2 Highlight the required protocol (‘RCI’ or ‘None’) and press the OK key to return to
the Protocol page.
For information on how to configure the parameters for communication over an Ethernet
connection, see ‘Configure the Ethernet setup’ on page 17.
69472
To Next Page
Loading...
