Chapter 6: Look after your printer
FA69315–5 English 55 Linx 5900 & 7900 Quick Start Guide
7900 (IP65 version) printer
The air filters in the 7900 (IP65 version) and the 5900/7900 are in the same
position. The 7900 (IP65 version) has an access panel to make it resistant
to water and dust.
You cannot clean the air filter of the 7900 (IP65 version) printer. You must
replace the air filter.
To replace the air filter:
1. Loosen the screw and release the filter access panel.
2. Pull the filter handle until the filter is removed from the filter housing.
The filter fits tightly into the housing. Refer to the illustration below:
Figure 6-11. Remove the air filter (7900 IP65 version)
3. Make sure that the new filter is clean and the type of filter is correct.
Make sure that there is no dirt in the filter housing.
4. Fit the new, Linx-approved, replacement filter into the filter housing.
Make sure that you correctly fit the filter—the direction of the handle
must be away from the printer, as shown in Figure 6-11.
5. Close and fasten the access panel.
To Next Page
Loading...
