25
WWW.LIONPROTECTS.COM
CONDUCTING THE TRAINING EVOLUTION
1. Press the START button on the Setup Remote.
2. Using the PASS Technique, the trainee should Pull the extinguisher pin, Aim the hose
at the base of the re, Squeeze the handle and Sweep the extinguisher. The same
general PASS technique should be employed with the BullsEye
™
laser extinguishers,
an air/water SmartExtinguisher
®
, or a water can.
3. If the trainee properly aims and sweeps the extinguisher, the ames will eventually
be extinguished.
4. If the trainee does not aim and sweep properly, the ames will not be fully
extinguished. Flames have the ability to rekindle or are-up if not fully extinguished.
5. SmartExtinguishers and BullsEye extinguishers are designed to provide the trainee
with a discharge time that corresponds to an actual dry chemical extinguisher of the
same size.
6. ATTACK’s digital ames can be stopped at any time by pressing the STOP button on
the Setup Remote.
7. Note that commands from the setup remote may be ignored by the panel when laser
extinguishers or digital hand lines are being aimed at the ATTACK panel.
8. For the next evolution, ensure that the training extinguishers are recharged.
a. To reset the laser extinguisher for the next trainee, simply press the power
switch again. This prepares the extinguisher for the next evolution and will
enable a full “discharge” for the next user.
b. For the air/water SmartExtinguishers, recharge with compressed air until the
gauge reads 100 PSI (6.9 bar) and reset the pin. Tamper Seals can be placed
on the extinguisher pin to provide additional realism and further challenge
trainees. Water rells are required approximately every ve or seven discharges
depending on the size of the extinguisher.
To Next Page
Loading...
