ATTACK
™
DIGITAL FIRE TRAINING SYSTEM
28
WWW.LIONPROTECTS.COM
12. MAINTENANCE INSTRUCTIONS
GENERAL MAINTENANCE
• Never loosen any of the screws on the back of the ATTACK
™
panel. Doing so will allow
water into the unit causing failures, it will also void the product warranty.
• There are no user serviceable parts inside the ATTACK panel.
• Surfaces of the appliance may be cleaned with a general non-abrasive household
cleaner. Only clean ATTACK when it is NOT powered on, in use, or plugged in.
• Do not use petroleum-based cleaners to clean any component of the appliance.
• Inspect ATTACK and SmartExtinguishers prior to each use.
• Fully charge the laser driven extinguishers prior to and after each training session.
• All damaged parts must be replaced prior to operating ATTACK. Do not use ATTACK
if there are any signs of damage. The replacement parts shall be specied by the
manufacturer. Using any other parts may cause ATTACK to function improperly and
could lead to injury. Use of unauthorized parts will void the warranty.
• Do not inspect, adjust, or service the laser module.
• Inspect the air/water SmartExtinguishers prior to each use.
• If there are any signs of damage or rust on the cylinder body, do not use the
SmartExtinguisher
®
and contact LION immediately for further support.
Refer to the Smoke Generator User’s Manual for information on maintaining the
Smoke Generator.
DO NOT USE LUBRICANTS ON ANY PART OF THE SYSTEM.
• Hard water deposits may collect on the SmartExtinguisher siphon tube.
The siphon tube should be wiped down and cleaned after use. Cleaning
can be done with a general household cleaning agent and a cloth.
• The SmartExtinguishers should be Hydro-Tested by a qualied Fire Equipment Dealer
every year as if they were actual re extinguishers.
To Next Page
Loading...
