11
WWW.LIONPROTECTS.COM
8. OPERATING INSTRUCTIONS
8.1 SYSTEM SETUP AND INSPECTION
Unpack all parts, removing any packaging materials. Check for visible signs of damage
that may have occurred during transport and call LION or an authorized dealer immediately
to report any concerns.
SETTING UP THE ATTACK™ BASE UNIT FOR USE WITH A HOSE LINE
1. Do NOT use ATTACK without reading the entire User’s Manual rst.
2. The ATTACK base unit must be supported by either the “weighted base” or the “wall
mounting bracket” before using with a hose line or water extinguisher.
WEIGHTED BASE SETUP
1. To begin the set-up process using the weighted base, put the base on a at hard
surface that can hold at least 500 lbs. (226.8 kg).
2. Position the base such that the ATTACK panel will face the desired direction. You
cannot reposition the weighted base when it is lled with water.
3. Open up the weighted base by unsnapping the two straps holding the two halves of
the base together.
4. Position the weighted base so the side of the base with the ridges is on the oor,
and the smooth side faces up.
5. Unfold the base such that the two sliding support legs fully extend and lock into
place. The stop on the support legs prevents the legs from collapsing.
STEP 3 STEP 4 STEP 5
>
continues
To Next Page
Loading...
