Setting a specific voltage
Y
ou may adjust the voltage to a setting of your choice with the red knob on the CAB-1
Remote Controller if you choose not to select a preset voltage. While turning the red knob
on the CAB-1 Remote Controller, you can examine the intensity of the lamps and the operation
of the accessories. Once you have fine-tuned the performance, you can save the voltage level.
1. Press TR or ENG (determined when you assigned the ID#) and the ID# of the AVC unit on
the CAB-1 Remote Controller.
2. Use the red knob on the CAB-1 Remote Controller to adjust the voltage. For fine
adjustments, use the BOOST button on the CAB-1 Remote Controller to increase the voltage
by one step or the BRAKE button to decrease the voltage by one step.
3. Press AUX1, AUX2, and enter a number from 0 to 9. The new voltage setting will be saved to
that number.
4. Press SET on the CAB-1 Remote Controller while the RUN/PROG switch on the AVC is set to
RUN.
At this point, a new voltage has been assigned. Press L, M, or H to reset the AVC to the factory default
settings.
9
Wiring your Accessory Voltage Controller
To Next Page
Loading...
