Lippert Components LCI Level-Up User Manual

Rev: 06.29.18
Page 14
CCD-0001535
What Is Happening? Why? What Should Be Done?
System will not turn on
and On/Off indicator
light does not illuminate.
Coach ignition not in
RUN position.
Turn ignition to RUN position.
Parking brake not set. Set parking brake.
Controls have been
on for more than four
minutes and have timed
out.
Turn ignition OFF and then back ON.
Control panel turns on
but turns off when jack
button is pushed or
displays "Low Voltage."
Low voltage on battery. Start coach to charge battery.
Control panel turns on,
coach will not auto level,
"Jacks Down" displayed,
jacks are retracted.
Low fluid level.
Change fluid level in reservoir. If fluid is low, add
fluid to ½" from top of reservoir with jacks retracted.
If JACKS DOWN light remains on, call Lippert Service.
Jacks will not extend
to ground, pump is
running.
Little to no fluid in
reservoir.
Add fluid as recommended. See Page 13.
Leg valve is inoperative. Clean, repair or replace.
Electronic signal is lost
between control and
leg valves.
Trace wires for voltage drop or loss of signal. Repair
or replace necessary wires or replace control pad.
Any one or two jacks will
not retract.
Hose damaged or
unconnected.
Replace with new hose or reconnect hose.
Valve inoperative. Replace inoperative valve.
Electronic signal is lost
between control and
solenoid.
Attempt to retract jacks in MANUAL mode. If
successful, replace control pad. If not, test for voltage
drop between control pad and leg valve. Repair bad
wiring or replace defective board or valve.
"Jacks Retracted" does
not display when all
jacks are retracted.
Low fluid level. Add fluid as recommended. See Page 13.
Retract press switch
inoperable.
Check connection or replace.
Alarm sounds and
"Jacks Down" light starts
flashing while traveling,
jacks are fully retracted.
Low fluid level. Add fluid as recommended. See Page 13.
Retract press switch
inoperable.
Check connection or replace.
Jack bleeds down after
being extended.
Valve Manual Override
open.
Close override. See Page 12, Fig. 8.
Control panel powers
up, screen displays "Low
Voltage."
Engine not running. Start coach engine.
No power to control
panel
Tripped circuit breaker. Reset.
Ignition not ON. Turn ignition ON.
Auto level function does
not finish
Error code "Unable to
Finish Leveling".
Move coach to a more level site.

Lippert Components LCI Level-Up Specifications

General

Brand	Lippert Components
Model	LCI Level-Up
Category	Control Systems
Language	English