To Next Page

To Previous Page

lci1.com 574-537-8900 Rev: 03.21.19

Solera

Universal Hardware

Manual Awning to

Solera 18V Power Awning

(For Aftermarket Applications)

CCD-0001267

NOTE: Use caution when retracting the awning manually.

The use of a step stool or ladder may be required to

completely retract the awning.

3. When the awning is completely retracted, replace the

rubber grommet in the drive head assembly (Fig.35A).

NOTE: The motor’s internal drive system prevents the

awning from moving (extend or retract) on its own. If the

motor is damaged or disabled, be sure to secure the

awning in the retracted position with a strap around both

the outer arm and the mount arm (Fig.37A) before the

manual override nut is released.

DURING INCIDENTS OF HIGH WIND, HEAVY RAIN

OR EXTENDED TIME AWAY FROM THE UNIT, IT IS

ADVISABLE TO RETRACT THE AWNING COMPLETELY

TO PREVENT DAMAGE TO THE AWNING AND THE UNIT.

Fig.37

Maintenance

Fabric Care

NOTE: If the awning is retracted while wet, extend the

awning and let it dry as soon as conditions allow before

retracting. This will help prevent the formation of mildew

and add greatly to the life of the awning. Mildew does not

form on the fabric itself, but on the accumulated dust, dirt

and grime.

NOTE: Periodically clean vinyl or woven acrylic fabric

using a mixture of ¼ cup of dish soap and 5 gallons of

warm water. Liberally apply the mixture on the top of the

fabric and retract the awning for 5 minutes. This will apply

the mixture to the bottom of the fabric as well. Extend the

awning and hose off with fresh water. Repeat if necessary.

Allow to dry before retracting.

Lippert Components Solera User Manual

Other manuals for Lippert Components Solera