Listen lt-800 - Preparing Listen Receivers; Receiver Setup and Configuration

LISTEN TECHNOLOGIES CORPORATION +1.801.233.8992 1.800.330.0891 Fax: +1.801.233.8995
Internet: www.ListenTech.com All specifications subject to change without notice.
23
R
Open the Front Access Door.
Grip the two tabs with your thumb and index finger,
and pull the door downward and toward you.
Select Battery Type.
The BATTERY selection switch is located inside the
battery compartment. The unit is shipped with the
switch in the ALKALINE position. If you are using
Nickel Metal Hydride (NiMH) batteries, move the
switch to the NiMH position. Do not move the
switch if you are using any other battery type.
Battery Select
Switch
SQ Switch
Preparing Receivers For Use Cont.
WARNING: Do not place the BATTERY select
switch in the NiMH position if you are using any
type of battery other than Nickel Metal Hydride
batteries. The NiMH position will attempt to
charge the batteries. Charging non-NiMH
batteries can result in physical harm, destruction
of property and/or fire.
Set SQ Switch.
See “What is SQ?” on Page 2. The SQ switch is
located next to the BATTERY select switch (see
diagram below, left). Your receiver has been shipped
with the SQ switch in the ON position. If other
receivers in your system do not have SQ, or if your
transmitter does not have SQ, you will need to turn
this feature off. Use a screwdriver or pen to slide the
switch to the OFF position.
Place Batteries in Unit.
Place two AA batteries in the compartment, making
note of the battery polarity, and verifying that the
BATTERY select switch is in the correct position for
the type of batteries you are using.
Connect an Earphone or Headset to the Unit.
Your headset or earphone will connect to the jack on
the top of the unit. Either mono or stereo connectors
may be used with a Listen receiver. Make sure you
push the plug all the way into the jack.
Turn the Receiver On.
Receivers are turned on by rotating the volume knob
counterclockwise. The red LED on top of the unit
should activate and, on the LR-400 and LR-500, the
LCD display should illuminate. If they do not, make
sure you have installed the batteries correctly and
that you are using fully charged batteries.
3
4
5
Preparing Listen Receivers For Use
6
7
8
Turn volume knob
counterclockwise to turn
on
Red LED will
illuminate when
on
LCD display will
activate when on (LR-
400 and LR-500)