LiteOn EVO 6800 Series - Page 131

128
<5>The maxium of parameter setting by d1-02 (maximum output frequency) and L2-00 (frequency command
limit) will be changed
<6> Contact the local distributor for any malfunction.
<7> When A1-03 is initialized, this parameter will not be restored to factory settings.
<8> When A1-07 = 1, the preset values of the following parameters will be modified
Parameter
Name
Description
B1-01
Operation command selection 1
1 control circuit terminal (sequence control input)
B5-01
Proportional gain(P)
3.00
B5-02
Integration time(I)
0.4s
C1-00
Acceleration time 1
5.0s
C1-01
Deceleration time 1
5.0s
E3-06
Terminal A2 signal level selection
1 (4~20mA)
E3-07
Terminal A2 function selection
8 (PID feedback)
P3-01
Stall prevention value during
acceleration
100%
P3-06
Stall prevention value during
operation
100%
P5-02
Fault retry interval timing
3600.0s
<9> When F1-18 = 1, the factory settings, upper and lower limits and units of some parameters will be changed
as follows
Parameter
Description
Default
Min.
Max.
Unit
F1-01
(Switch mode) pressure
operation interval
0.3
0.1
99.9
0.1bar
(kg/cm
2
)
F1-03
(Water detection) Pressure raise
level
0.2
0.0
50.0
0.1bar
(kg/cm
2
)
F1-07
PID control recovery level setting
0.3
0.0
99.9
0.1bar
(kg/cm
2
)
F1-08
PID steady state allowable error
0.1
0.0
50.0
0.1bar
(kg/cm
2
)
F1-16
Feedback pressure change
0.5
0.0
50.0
0.1bar
(kg/cm
2
)
* The content of parameters will make some adjustments. Please refer to the manual on the
website. https://liteon-ia.com/downloads