LiteOn EVO 6800 Series - Page 130

127
Parameter
Name
Description
Unit
U3-14
Run Command
Source Selection
Displays the source for the frequency command as XY-nn.
XY-nn=00-00: Local
X: Command Used
1: Command 1
2: Command 2
Y-nn: Command Source
0-00: Keypad
0-01: Control Circuit Terminal (Sequence Control Input)
0-02: Modbus communication
-
U3-15
Voltage
compensation
amount
Display the voltage compensated by the inverter
0.1V
U3-16
Slip compensation
frequency
Display frequency of inverter slip compensation
0.01Hz
U3-17
Drive Overload
Estimate (oL2)
Displays the value of the drive overload detection
accumulator. An oL2 will be triggered when reaching
100%.
1%
U4: PID Monitors
U4-00
PID Feedback
Displays the PID feedback value as a percentage of the
maximum output frequency.
0.01%
U4-01
PID Input
Displays the PID input value as a percentage of the
maximum output frequency.
0.01%
U4-02
PID Output
Displays the PID output value as a percentage of the
maximum output frequency.
0.01%
U4-03
PID Target
Displays the PID target value as a percentage of the
maximum output frequency.
0.01%
U4-04
PID Differential
Feedback
Displays the difference of both feedback values when 10
is set to both E3-01 and E3-07.
0.01%
U4-05
PID Feedback 2
Displays the adjusted feedback value if differential
feedback is used (U4-00 to U4-04)
The value in U4-00 and U4-05 will be the same if
differential feedback is not used.
0.01%
U4-08
<7>
PID Output 2
Displays the PID output 2 value as a percentage of the
maximum output frequency.
0.01%
<1> The default is determined by the drive capacity, control method and ND/HD mode.
<2> Refer to user manual for details. http://www.liteon-ia.com.tw/ENG/download.php
<3> Double the value for 440V class AC drives.
<4> The parameter can be set during run.