52
◼ Follow the instructions below to remove the jumper if an even lower current leakage to a
even lower level.
◼ Removing the jumper may increase the signal interference
.
4.2.2.6 Ring Terminal
◼ Main circuit terminal should be used with crimp ring terminal wiring，
◼ Please refer to the diagram about ring terminal size, where the 8 AWG and 10 AWG bare
recommend using W size must be less than 10.5 mm, d2 size must be greater than 5.0
◼ Ring terminal shall be insulated cover of the terminal block wiring, which can form a reference
KST RVBS8-5 & KST RVB5-5 or similar size ring terminals to facilitate wiring and other
operations
To Next Page
Loading...
