LiteOn EVO 6800 Series - Page 94

91
Parameter
Name
Description
Setting Range
C6: Carrier Frequency
C6-00
Carrier
Frequency
Selection
Sets the switching frequency of the drive
output transistors. Adjust this setting to
reduce audible noise and leakage current.
0: Err
1: Retain
2: 2.0 kHz
3: 3.0 kHz
4: 4.0 kHz
5: 5.0 kHz
6: 6.0 kHz
7: 7.0 kHz
8: 8.0 kHz
9: 9.0 kHz
10: 10.0 kHz
11: 11.0 kHz
12: 12.0 kHz
13: 13.0 kHz
14: 14.0 kHz
15: 15.0 kHz
Default: Determined
by A1-02 and o2-03.
Once A1-06 is
redefined, the
default will be
changed accordingly
Range: 0 to 15
C7：SVVC Command
C7-00
Proportional Gain
This gain adjustment depending on the
application field, if the load is heavy increase
this value, otherwise reduce this value
Default: 100%
Factory setting when
D1-01 is not equal to
F: 0
Minimum: 0%
Maximum: 250%
C7-01
SVVC mode slip
adjustment
If the slip compensation is not obvious or the
current is too large at low speed, the parameter
can be adjusted to improve (low speed SVVC
compensation constant correction)
Default: 100
Min.: 0
Max.:250
Group L, Frequency Command
L1: Frequency Command
L1-00 <4>
Frequency
Command 1
Default:5.00Hz
Min.: 0.00Hz