LiteOn EVO600043S1D5E20F User Manual

95
□ Motor No-Load Current Setting
Sets the motor no-load current when running at no-load voltage and rated frequency. This
information is not written on the motor nameplate. Contact the motor manufacturer for the
information.
□ Number of Motor Poles Setting
d2-03 is only enabled in Closed-Loop V/F Control and Closed-Loop Vector Control. Enter the
number of motor poles written on the motor nameplate.
□ Motor Line-To-Line Resistance Setting
d2-04 will be set automatically during Auto-Tuning. However if Auto-Tuning cannot be
performed, contact the motor manufacturer for the test report. Use the line-to-line resistance
listed in the rest report to calculate the line-to-line resistance by the following formula.
· E-type insulation: the resistance value (Ω) listed on the test report at 75°C × 0.92
· B-type insulation: the resistance value (Ω) listed on the test report at 75°C × 0.92
· F-type insulation: the resistance value (Ω) listed on the test report at 115°C × 0.87
□ Motor Leakage Inductance Setting
d2-05 will be set automatically during Auto-Tuning.
□ Motor Rotor Resistance and Mutual Inductance Setting
6.6 Group E, Multi-Function Terminals
E1 Multi-Function Digital Inputs
 E1- 00 to E1- 05 Terminal S1 to S6 Function Selection
Assigns functions to multi-function terminals S1 to S6. Set this parameter according to Table
6.18.
No.
Name
Setting Range
Default
E1-00
Terminal S1 Function Selection
0 to 73
0 : 2-Wire Sequence Control (Forward/Stop)
E1-01
Terminal S2 Function Selection
0 to 73
1: 2-Wire Sequence Control (Forward/Stop)
E1-02
Terminal S3 Function Selection
0 to 73
23 : External Fault
E1-03
Terminal S4 Function Selection
0 to 73
39: Fault Reset
E1-04
Terminal S5 Function Selection
0 to 73
9: Jog Frequency
E1-05
Terminal S6 Function Selection
0 to 73
19: Baseblock Command (Normal Open.)
Table 6.18

LiteOn EVO600043S1D5E20F Specifications

General

Brand	LiteOn
Model	EVO600043S1D5E20F
Category	Controller
Language	English