Page 26 Chapter 4: How to match communication with Inverter
4.3. Connection with the inverter
This section describes how to connect the Controller to inverters. Manufacturers may upgrade
their products resulting in hardware communication interface changes. If communication is not
possible in the application according to the following wiring method, please contact us.
The CAN/RS485 communication port of HomeGrid is connected to the communications
interface of inverter.
Connect to the Victron inverter
Connect to the DEYE inverter
Connect to the Growatt inverter
Connect to the Sofar inverter
Connect to the Solis inverter
Connect to the Goodwe inverter
Connect to the Sermatec inverter
Connect to the Sol-ark-12k inverter
Connect to the GreenCell inverter
Connect to the Must inverter
NOTE:
●The above CAN and RS485 communication connections are not connected the ground wire. In the presence of
high interference, adding a ground wire is recommended.
To Next Page
Loading...