Page 24 Chapter 4: How to match communication with Inverter
4. Matching the Controller to the Inverter
4.1. Supported brands
A Stack’d system must be connected to an inverter to convert the DC power from the batteries
to AC current to run things like lights, appliances, and HVAC units. At other times, the inverter
will provide DC power to recharge the batteries. The Stack’d Controller Module can exchange
information with a smart inverter regarding desired voltages, currents, and other information.
HomeGrid has programmed the Stack’d system to work with smart inverters from several
companies. All the installers must do is connect the controller to the inverter with the proper
cable and select the proper inverter protocol as shown in Section 2.5.
HomeGrid will program future Stack’d systems to work with more inverters. Check our official
website for the up-to-date list.
4.2. Inverter matching list
The list tab only lists the inverter manufacturers one of the same series products, general
inverter manufacturers in the same series of other products, the communication protocol are the
same, so our battery can be communicated with the other products of same series inverter, if
encounter a series of products can't communication, please contact us.
The following inverter matching list may not be up to date. The list may change according to
the software version upgrade, and the reference manual may does not change immediately
according to the software version upgrade. Therefore, if the user wants to get the latest inverter
matching support, please browse the official website to check the relevant documents。
The inverter manufacturer may upgrade its software version, which may cause problems in the
communication between our battery and the inverter. Therefore, before communicating with
the inverter, please confirm whether the software version of the inverter is consistent with the
list. If not, please contact us.
To Next Page
Loading...