Loadrite Sprint - How Do I Finish the Load; How Do I Put the Indicator into Standby Mode

2-13
LOADRITE Sprint User manual
2.4.5. Recall a bucketload
The Recall function is equivalent to lifting the same load again and can be used to correct mistakes. The last bucketload can be
recalled if it has been added, subtracted or cancelled. To recall a previously lifted weight, complete the following:
1) Press .
The last valid weight that was lifted will be displayed.
2) Complete the following:
If... Then...
the last action was an "add"
press .
The bucketload is subtracted from the short total and long total.
the last action was a "subtract"
press .
The bucketload is added to the short total and long total.
2.5. HOW DO I FINISH THE LOAD?
When you have finished adding bucketloads to the truck, you must clear the short total. To clear the short total, complete the
following:
 Press and hold
.
The short total will display briefly, followed by the Total Cleared message, then the Ready screen.
2.6. HOW DO I PUT THE INDICATOR INTO STANDBY MODE?
If you are not going to use the LOADRITE Weighing System for a while, you can put the Indicator into Standby mode by
completing the following:
Option 1
 Press and hold for 5 seconds. The Indicator will enter Standby mode.
Option 2
1) Press .
2) Press or to scroll up or down until Standby is selected, then press . The Indicator will enter Standby mode.
Option 3
The LOADRITE Indicator will automatically go into Standby mode if it is not used for two hours.
How do I exit Standby mode?
 Press any button to exit Standby mode. Either the Login screen or Ready screen will display.