WARNING: Activate the opener only when door is in full view, free of obstruction and properly
adjusted. No one should enter or leave gate area while door is in motion. Do not allow children to
operated push button or remote. Do not allow children to play near the door.
Your swing gate opener receiver and remote control transmitter are set to a matching code. If you
purchase additional remote controls, the gate opener must be programmed to accept the new remote
code.
Caution: If you lose one of any remote control, please learn all other remote controls to have a new
code for safety.
9. Set the automatic closing time:
When the Digital Display indicates “PA”, the gate opener enters into the setting the automatic closing
time mode. Press and release the “INC” or “DEC” Buttons, the Digital Display will show a “1”-“9” which
indicates the current automatic closing time. The minimum time is 1 minute, 9 minutes maximum. Each
time you press and release the “INC” Button, the figure increases by 1, and the timing increases by 1,
and the time increases by one minute. Each time you press and release the “DEC” Buttons, the figure
decreases by 1, and the timing decreases by 1 minute. When the timing is 0, it means the automatic
closing function is closed.
(Factory set is 6 minutes)
Press the “FUNC” button to store the data when the desired automatic closing time is set. The Digital
Display will indicate “Pb”
10. To set the Period of Soft Start
When the Digital Display indicates “Pb”, the unit is ready for setting Period of soft start.
You can press the “INC” or “DEC” Buttons to set the period of soft start. There is 1-9 second available for
setting. Press the “FUNC” button to store the data when the Period is set. The Digital Display will indicate
“PC”.
(Factory set is 3 seconds)
11. Program your Opener & Remote
When the Digital Display indicates “PC”, you can program your Opener & Remote.
Press and release “INC” button, the Digital Display will indicate “Ln”. Press the key twice on the Remote
Control, the “PC” will be show on the Digital Display after “Ln” flashing 4 seconds, now the opener has
learned the code.
Repeat the above steps. The Opener can learn up to six remote codes.
If no other setting is to be programmed right now, press and release “FUNC” BUTTON to store the data.
The Digital Display will indicate “Pd”.
12. Erase All Remote Control Codes
When the Digital Display indicates “PC”, press and hold the “DEC” Buttons more than 4 seconds, the all
codes in remote will be erased, Digital Display indicates “dL”. Then press and release “FUNC” button to
let the Digital Display indicating “PC”, now you can learn new code again.
13. Return to Factory set
When the Digital Display indicate “Pd”, Press and hold the “INC” Button more than 4 seconds, the all
data will return to factory set, the Digital Display indicates “dF”.
14. If all of data is set and no any change needed, press “FUN” Button, “- -” be shown on the Digital
Display, the unit enters standby.
To Next Page
Loading...
