19
5 Dispensing
5.4 Shutdown for Longer Periods of Non-use
• Disconnect the pneumatic supply from the controller.
5.5 Returning to Operation after Longer Periods of Non-use
• Reconnect the pneumatic supply to the controller.
• Check the installation according to Chapter 4.
• Return to operation according to Section 5.1.
6 Care and Maintenance
• Occasionally the o-ring at the reservoir lid 3 should be lubricated with the enclosed silicone
grease. This will prolong the life of the o-ring.
Clean hands after application of grease to assure surfaces to be bonded are clean. Otherwise
bonding might fail.
• Clean the sensor surface, the drip funnel and drip cup as required.
Both the bottle surface and the sensor surface must be free of condensed moisture!
• Check both the reservoir knobs 2 and the product feedline on a regular basis. If there is any
sign of cracks, replace them!
To Next Page
Loading...
