18
GB
Initial Setup
Turning the TV On for the First Time
1. Connect the mains cable to the mains socket after you have
completed all the connections.
2. Switch on the POWER ON/OFF switch at the back of the TV. At this
stage, the TV switches to standby mode. The red LED indicator will
illuminate on the front panel of the TV.
3. In standby mode, press the
button at the front of the TV or on the
remote control to turn your TV on. The red LED indicator will turn
green.
ON
OFF
To the mains socket
6. Press the buttons to select the country where you will operate the TV.
Press the OK button or the GREEN button to enter the Setup 3 menu. You
may press the RED button to return back to the previous menu.
7. Press the GREEN button to start the auto tune. Auto tuning will commence.
The display will show the progress of the tuning and the number of channels
found.
You may press the EXIT button to stop the auto tuning.
Always disconnect the TV from the mains socket when not in
use for a long period of time.
The
button at the front of the TV or on the remote control
is only used for switching the TV into standby, it does not
disconnect the TV from the mains power. To completely
disconnect the mains power, please remove the mains plug
from the mains socket.
4. The first time you turn the TV on, it will go straight into the First Time
Installation menu. (If you have already installed the TV using the Quick Start
Guide, please go to the next step “Selecting the Input Source” on the next
page.)
5. Press the
buttons to select the language you will use to operate the TV.
Press the OK button or the GREEN button to enter the Setup 2 menu.
L37DIGB10_IB_L37DIGB10_IB_110131_Annie.indd 18 11年1月31日 上午10:54
To Next Page
Loading...
Need help?
General
