To Next Page

To Previous Page

EPG (Electronic Programme Guide)

5. Press the button to stop recording. A pop-up window will display. Press the

buttons to select Yes and then press the OK button to stop recording.

3. During recording,

will be displayed on screen.

Press the

button again during recording to set Recording Duration Time.

Enter the recording duration time by using 0-9 buttons and then press the

OK button to confirm.

4. Press the DISPLAY button during recording to display the progress bar.

If the transfer rate is enough, the system will start initialising the recorder,

and may take a few seconds.

2. The system will automatically detect the transfer rate of the USB storage

device. If the transfer rate is not enough, a pop up screen will display.

Select No and replace with another USB storage device. Select Yes to start

recording anyway.

To Record the Current Viewing Programme

1. Press the GREEN button to record the current programme while on the

programme that you are currently watching. A pop-up window will display.

Press the

buttons to select Yes and then press the OK button to start

recording.

Alternative

While viewing the programme on screen, press the button to start

recording.

To Set a Timer Recording

In EPG menu, highlight the upcoming programme you want to record. Press the GREEN button twice and the TV will

automatically tune to the selected programme when it starts and start recording.

Recording will stop automatically when the disk is full.

• If the timer is set, the LED indicator remains green. When recording starts the green LED indicator will start to flash.

• If the timer is set when the TV is in standby mode, make sure your USB storage device is connected and switched on.

• Please note radio channels and subtitles in DTV programmes cannot be recorded.

To Set a Reminder for DTV Programmes

In EPG menu, highlight the upcoming programme you want to watch. Press the GREEN button and the TV will automatically tune

to the selected programme when it starts.

To Set a Reminder for Digital Radio Programmes

Press the TV/RADIO button to switch to Radio Mode and then press the EPG button to enter the EPG menu. Highlight the

upcoming programme you want to listen. Press the GREEN button and the TV will automatically tune to the selected programme

when it starts.

L37DIGB10_IB_L37DIGB10_IB_110131_Annie.indd 42 11年1月31日上午10:54

Logik L37DIGB10 User Manual

Questions and Answers: