Logik L610TL22E - Moving and Installing; Removing the Transit Bolts; Removing the Polystyrene Foam; Attaching the Sponge Strips

INSTALLATION
10
GB
Moving and Installing
Removing the Transit Bolts
The appliance should be adjusted with the transit bolts installed, and not tilted after they are
removed.
Four transit bolts keep the interior of the washing machine in place while it’s being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the
instructions detailed below.
Moving the Washing Machine from One Location to Another
Before you move the washing machine:
• Shut o the tap and run the washing machine to drain the water. Drain any remaining
water from the pump hose.
To remove the transit bolts:
1. Use a spanner to loosen the four bolts. They are located at the
rear of the washing machine.
2. Pull the bolts out horizontally. Make sure the entire bolt is
removed.
3. Push the four cover caps (included with your accessories) into
the respective bolt holes.
Don’t run the washing machine without removing the transit bolts, as this can cause
excessive vibrations and may damage your machine.
You’ll need the transit bolts again if you move the washing machine, so make sure
you keep them in a safe place.
Removing the Polystyrene Foam
Polystyrene foam is attached on the underside of the appliance for protection and support
during transportation. It needs to be removed before installation. Check and ensure the
underside is clear of polystyrene foam by tilting the appliance and have someone check the
underside of any un-removed foam.
Attaching the Sponge Strips
Stick the sponge strips at the bottom of the machine to
reduce any noise caused by the machine while operating.
• Two or more people are required to stick the sponge
strips.
• Put a thick towel or foam support on the ground, then
two people should carefully lower the machine on to
the towel or foam to prevent the machine from directly
lying on the ground.
• Stick the sponge strips at the bottom as showm in the diagram, then stand up the
machine after sticking.
short
strips
long
strips
L610TL22E_IB_5L_RC_Final240326.indb 10L610TL22E_IB_5L_RC_Final240326.indb 10 26/3/2024 3:49 PM26/3/2024 3:49 PM