14
DAB Operation
Ensure that you fully extend the aerial vertically before switching the unit on. When the unit
is connected to the mains power and then switched on from standby for the rst time, or
you have just performed a factory reset the unit will automatically enter into the DAB mode
and perform auto scan function.
During the scan the display will show “Scanning...”
together with a slide bar that indicates the progress
of the scan and the amount of stations that have been
found so far.
Once the scan has nished, the unit will select the rst alphanumerically found station.
Turn the SCROLL
/ dial to explore the found stations followed by pressing ENTER
button to select listening to the station.
If no stations are found after auto scan, the unit will show Full Scan. Turn the
SCROLL / dial to select between Full scan and Manual Tune, and then
press the ENTER button to conrm.
DAB Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has nished,
the rst alphanumerically found station will be automatically selected.
Full auto scan will not replace the DAB stations in memory. If you want to remove
all the previous scanned stations, system reset is required.
1. To activate auto scan, rst press the MENU button.
2. Turn the SCROLL
/ dial to select Full scan, and then press the ENTER button to
conrm.
3. The display will show “Scanning …” and a progressing slide bar.
4. All the stations that have been found will be stored automatically. To explore and select
listening to the found stations, turn the SCROLL
/ dial, and press the ENTER
button to conrm.
Secondary Services
You may see a “<” symbol after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra
services that are related to the primary station. e.g. a sports station may want to add extra
commentaries. The secondary services are inserted directly after the primary station in the
station list.
To select the secondary station, press the ENTER button when the “<” appears in
the display before the station name. When the secondary service ends, the unit will
automatically switch back to the primary station.
To Next Page
Loading...
Need help?
General
