8
Using the touch controls
• The controls respond to touch, so you don’t need to
apply any pressure.
• Use the ball of your finger.
• You will hear an audible tone each time a touch
is registered.
• Make sure the controls are always clean and dry,
and that there is no object (e.g. a utensil or a cloth)
covering them. Even a thin film of water may make
the controls difficult to operate.
Covering the controls
If you accidentally cover the controls or the
control panel is very dirty the hob will beep and
the display will flash 4 ‘Fs’.
Using your ceramic hob
Switching on and o
1. Touch the
control. The hob will switch
on and the power level 0’s will be displayed
and the active indicators will flash.
If no controls are touched, the hob will
switch off after 9 seconds.
2. Touch the
control again to switch the
hob off. If a cooking zone is still hot the
letter ‘H’ will be displayed to show its still
very hot then it will change to ‘h’ when
it’s hot but cooling.
• The ‘H’ symbols will flash in the display the first time your hob is connected and
switched on. This is because the hob has been heat tested at the factory, then switched
off while still hot. This may also happen if you are using the hob and you have a
power cut. This is not a fault. The ‘H’s’ will disappear from the display when you start
using the hob.
• Do NOT touch the cooking zones when the hob is switched on or when a ‘H’ or ‘h’
are displayed as the cooking zones will be hot.
• The touch controls may become very warm to the touch after prolonged use. Please
take care when opperating the controls they could be very warm.
* All images are for indication only; please refer to your individual unit for actual item.
To Next Page
Loading...
Need help?
General
