9
Selecting a cooking zone
Your ceramic hob has 4 cooking zones:
two small 145mm diameter zones, one medium 180mm
diameter zone and one large 210mm diameter zone.
1. Touch the desired cooking zone control to select
the cooking zone. The zone active indicator will
flash for 8 seconds to show that the zone is ready
for you to select a power level.
Setting the power level
Each cooking zone has 9 power levels and
a warming setting.
1. Select a cooking zone, then while the zone
indicator light is flashing touch the
or
controls to select a temperature setting. The zone
selection will cancel if no temperature selection
is made within 8 seconds.
2. You will hear a bleep and the zone indicator light
will switch off when the cooking zone has reached
your desired setting.
If you want to adjust the temperature setting at any point you will first have to select the cooking zone,
adjustments can only be made when the zone indicator light is flashing. It will flash for 7 seconds.
Warming setting
This hob features a warming setting on all cooking
zones. Selecting the warming setting will keep food
warm at a constant 65°C.
1. Select the cooking zone by touching the cooking
zone control.
2. While the zone indicator light is flashing, touch the
control to select power level 1, then touch
the
control. The symbol ‘ ’ will appear on
the display.
* All images are for indication only; please refer to your individual unit for actual item.
• Occasionally the heated areas may be seen switching on and off when higher
heat settings are used. This is due to a safety device, which prevents the glass
from overheating. Some switching on and off when cooking at high temperatures,
e.g. deep fat frying is quite normal, causes no damage to the hob and little delay
in cooking times. Excessive switching may however be caused by the use of an
unsuitable saucepan or a saucepan which is smaller than the heated area. If excessive
switching occurs, discontinue the use of the saucepan.
• To improve performance, and reduce energy, always use pans with close fitting lids.
Do NOT touch the cooking zones when the hob is switched on or when a ‘H’ or ‘h’
are displayed as the cooking zones will be hot.