LONCIN LC2V80FD - Wiring Diagram; Powered Starting System with Oil Protection

Part IV Faults Diagnosis
- 25 -
4-1 Difficulty of engine in starting
(Stop for several minutes before restarting)
(Refer to Section 3-6)
(Refer to Section 5-2-9)
(Refer to Section 5-2-9)
(Refer to Section 5-2-7)
(Refer to Section 5-2-7)
(Refer to Section 5-2-7)
(Refer to Section 3-5)
(Replace ignition switch)
(Refer to Section 5-2-6)
(Refer to Section 5-2-6)
(Refer to Section 3-5
Difficulty in
starting
Fuel system
Ignition system
Compression
system
(Clean or replace)
(Refer to Section 5-2-4)
(Clean fuel filter screen)
(Add fuel oil into the fuel tank)
Insufficient fuel
Fuel filter screen blocked
Fault or improper adjustment of carburetor
Air cleaner dirty
Improper clearance of spark plug
Improper clearance between ignition coil and flywheel
Fault of ignition coil
Fault of ignition switch
Fault of spark plug
Improper clearance of valve
Gasket of cylinder head damaged
Loosened cylinder bolt
Seal of valve not good
Excessive wear of cylinder/piston/piston ring
Excessive wear of camshaft
Excessive engine oil
(Replace flywheel)
Insufficient magnetic density