Chapter IV Disassembly & Repair
- 34 -
4-4-3 Flywheel/ignition coil/igniter/hand starter
a. Disassembly/assembly
Flange bolt: M8 × 28
Torque: (30~36) N•m
Bolt M6 × 65 (4)
Toque: (7 ~ 13) N•m
Disassembly:
Disassemble with flywheel
remover (a special tool).
Prohibit tapping with
hammer.
Assembly：
Remove the soil and grass attached around
these parts prior to assembly and note the
assembly direction.
Bolt: M6 × 8, Four
Torque: (8 ~ 12) N•m
Assembly/disassembly:
Check if the insulated cost is
cracked or damaged prior to
assembly to avoid electric
leakage.
Note: do not damage the
blade during maintenance.
Assembly/disassembly:
Remove the dust in fan
housing before assembly.
To Next Page
Loading...
