LONCIN LC3500i - Page 40

Chapter IV Disassembly & Repair
- 35 -
c. Disassembly/assembly (starter assembly)
The maintenance of hand-starting parts may cause personal injury accident, so please wear protective
glasses and do not make the starting return spring popup.
hexagonal-head shaft shoulder bolt
Assembly:
Coat the thread
retardant on the thread.
Drive guide plate
Assembly:
Make the end of drive
cam expose from the
gap of guide plate
during assembly.
compressed spring
Assembly:
Grease shall be
coated.
Drive cam
Assembly:
Assemble the return spring
on pull rope disk then
assemble the pull rope disk
on the cover.
Pull rope disk
Start return spring
Torsional spring
Note: do not make the return
spring popup during assembly. In
addition, wear gloves for
operation.
Assembly:
Hang the hook outside in the slot
of spool of pull rope disk, and
then hang the hook inside on the
jack catch of pull rope disk cover.
Pull rope
Assembly:
Check whether the pull rope
is broken or worn prior to
assembly.
Pull rope disk
Handle of pull rope
Assembly:
Check whether it is
broken or worn prior
to assembly and note
the assembly
direction.