LONGER Cube2 - Cube2 Platform Adhesion and Curling FAQ

25
Question 5:After the machine heats up, the filament is discharged
normally. However, when the printing is performed for the first time,
the curling occurs on the platform. After printing several layers, the
filaments get out of the platform. What can I do？
1. After the user gets the 3D printer, if the leveling is found to be curled on the
first layer of silk, it feels like it is gently falling on the platform. It can be judged
that the leveling is not adjusted, and the nozzle is too high from the hot bed. ,
2. At this point we need to re-level, the quality of the leveling can largely
determine the success rate of the part printing.
3. In addition, in order to ensure good contact between the model and the
platform, we can set the larger plane of the model face down when slicing, and
can also be set in the slicing software to add Raft to the model, which can make
the model stick to the platform. Firm.