Need help?Do you have a question about the LONGER LK4 Pro and is the answer not in the manual?
General| Build Volume | 220 x 220 x 250 mm |
|---|---|
| Layer Resolution | 0.1-0.4 mm |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Supported Filaments | PLA, ABS, TPU |
| Display | 4.3-inch Touchscreen |
Essential safety guidelines for operating the 3D printer, covering nozzle temperature and electrical safety.
Specifies operating conditions and technical details of the LK4 Pro 3D printer.
Introduces machine parts and guides through the assembly process, including wiring.
Guides on setting the correct voltage and performing the bed leveling procedure.
Explains the primary and secondary interfaces for machine control and operation.
Details the functionality of the Home, Move, and Tune screens for basic printer control.
Covers accessing advanced functions (Utilities) and managing print jobs (Print).
Guides for installing Cura, configuring settings, and preparing models for printing.
Explains how to configure various print parameters within the Cura software.
Instructions for connecting the printer for online operation and driver installation.
Explains power failure recovery and filament run-out detection features.
Guides for updating firmware and troubleshooting common problems like filament discharge.
Addresses issues with bed leveling, print adhesion, and loose components.
To Next Page
