Need help?Do you have a question about the LONGER Cube2 and is the answer not in the manual?
General| Layer Resolution | 0.05-0.3 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Nozzle Temperature | Up to 260°C |
| Bed Temperature | Up to 100°C |
| Connectivity | USB, SD Card |
| Supported Materials | PLA, ABS, PETG, TPU |
Provides essential safety measures for operating the printer, including handling hot parts, electrical safety, and filament storage.
Explains the step-by-step process for leveling the print bed to ensure proper first-layer adhesion and print quality.
Explains how to use Cura for slicing models and preparing them for offline printing.
Outlines essential parameters within Cura, such as layer height, shell thickness, fill density, and temperatures.
Details the process for resuming a print job that was interrupted due to a power outage.
Addresses firmware updates and troubleshooting filament discharge problems.
To Next Page
