LORCH MX 350 EU - Page 17

Messages
LORCH
Co de Error
Cause Possible remedy
E 22 Mains undervo lt a9e
Mains voltage on power unit is t oo Check mains voltag es
low
E25 Idle generator Idle generator raulty Inform Servi ce
E30
Error configuration
Faulty or wrong pc- board, wrong
Inform Service
software sys t em installed
E 31 Communications fault CAN bus commu nication fa ulty Switch the equipment off and on again
E32 FP GA FP GA faulty Inform Se rv ice
E 33 Power section
Power
module not symmetrical Inform Service
E34 Fans
Fan current
fa ulty Info rm Service
E40 Voltage detection
Voltage measurement faulty at the Inform Service
socket
Tab . 6. Error messages
10.13 - 17 -