75
Using the PC/Mac Client Software
Configuring Motion Detection Settings
To configure motion settings:
1 Cl
ick the Remote Setting, and click Alarm>Motion.
2 Co
nfigure the following motion recording parameters:
• Channel:
Select the channel you wish to apply the settings to.
• Ena
ble: Select this checkbox to enable motion recording.
• S
ensitivity: Select the desired motion detection sensitivity. The greater the value, the greater
the motion sensitivity.
• Buz
zer: Select OFF to disable the buzzer when the system detects a motion event or select
the duration of the buzzer after the system detects a motion event.
• Alarm Out: Sel
ect the checkbox to trigger connected alarm devices.
• Fu
ll Screen: Select the checkbox so that the channel goes into full screen mode when motion
is detected.
• Ena
ble Record: Select to enable system recording when motion is detected.
• Po
st Recording: Select the post-recording time after a motion event occurs.
• Rec
ord Channel: Select the channels that should record during a motion event.
• Sho
w Message: Select the checkbox to enable the system to display a warning message
during a motion event.
• Send Email:
Select the checkbox for the system to send a email notification during a motion
event.
3 Dr
ag your mouse cursor in the window to select the desired area to monitor the channel for
motion.
4 Cl
ick Save to apply your settings.
Configuring your System to "Beep" During Motion
You can set your system to "beep" during motion. This is useful to notify you if someone
enters or exits an area.
To configure the system to "beep" during
motion:
1 Cl
ick the Remote Setting tab, and click Alarm>Motion.
2 In the Channel dr
op-down menu, select the channel you wish to configure.
Click and drag to configure
motion detection areas
Red: Motion detection enabled
Clear: Motion detection disabled
To Next Page
Loading...
Need help?
General