Using the Main Menu15
To configure Email Alerts:
1. From the Main Menu, click
and then select Network>Email.
2. Check Enable to enable email notifications.
If you want to use Lorex’s email server (recommended):
1. Check Lorex Mail to use the Lorex email server to send out alarm notifications. This is
the recommended setting.
2. Configure the following:
• Receiver: Enter the email address that will receive alerts.
• Sender: Enter the sender’s email address.
• Subject: Enter the subject line for the email alert.
• Attachment: Check to include a jpg image attachment of the camera.
Note
You must enable the Snapshot option for motion detection on each camera you would to receive
attachments. For details, see 15.3.7 Configuring Motion Detection , page 55.
• Event Interval: Enter the interval between alert emails.
• Health Enable: Check to enable health check emails. Health check emails will be
sent periodically to ensure that the system is functioning normally.
• Interval: Enter the interval in minutes for health check emails.
3. Click Test to send a test email.
4. Click OK to save settings.
#LX400014; r. 2.0/15899/15899; en-US
54
To Next Page
Loading...
Need help?
General