Controlling the PTZ camera with LNR / NR Series NVRs
6
2. Click the Pattern tab.
3. Under Pattern, enter the pattern you would like to configure.
4. Move the camera into the desired start position and click Start.
5. Move the camera into the desired end position and click End.
6. Right-click to return to the advanced PTZ controls window.
To run a pattern:
• Under No., select the number of the pattern you would like to go to and
click
.
NOTE
• The camera's full panning range is 355°. However, we recommend you do not make
the camera pan more than 270° between any two points in a pattern.
• For instructions on how to control the PTZ camera using the smartphone or tablet app,
refer to your NVR's instructional manual.
#LX400075; r.41474/41994; en-US
22
To Next Page
Loading...
