Lotus Evora - Vehicle Speed Sensor

Page 50
Lotus Service Notes Section EMR
Vehicle Speed Sensor
P0500 Vehicle Speed Sensor “A”
Description
This input to the ECU is from the ABS module via CAN.
Monitor:
• Continuous
Enable Criteria:
• Followingconditionsmustoccurfor5seconds
• Enginespeed>1800rpmand<5010rpm
• Baro>756mbar
• Engineinamodethatindicatesthatthevehiclemustbemoving.
Malfunction Criteria:
• KMH<5kmh
Potential failure modes:
• ABSmodulefailure
• CANbuscommunicationerrortoABScontroller
Diagnostic Mask:
• TheMILwillbeilluminatedifafaultispresentfortwoconsecutivetrips.
2009/02