Page 10
Lotus Service Notes Section OK
Licence Plate Fitment
Front
The mounting plinth for the front licence plate is screw fixed to the front clamshell, and is slightly curved in
plan. Typically, the plate is secured using double sided tape in conjunction with two fixing screws with suitable
blind fix nuts (e.g. Rawlnuts). The plate should be aligned with the bottom edge of the plinth to reduce potential
damage from grounding or kerbs, whilst providing the minimum restriction to radiator airflow.
Rear
The rear licence plate should be mounted on the surface of the rear transom recess using double sided
tape and/or fixing screws at the dealer's/customer's discretion. Ensure that any holes drilled through the body
are suitably weather sealed.
To Next Page
Loading...
