LS ELECTRIC XGT Series - How to Use XG5000

Chapter 5 High-speed Link Setting
5-2
5.2 How to use XG5000
XG5000 usage for Rnet I/F module is as shown below.
XG5000 execution
2) Reading I/O information
3) High-speed link setting
(1) Communication module setting
A) Communication module setting: Rnet
- Module type, Base, Slot
B) Communication period setting
C) Data setup in case of emergency
-CPU module error, CPU module stop
(2) Block setting
- Read area/Save area address setting
Reading Rnet I/F module information
and click “I/O Sync”.
Connects High-speed link and Rnet I/F module
(The module information get through ‘Read IO
information’)
1) Project → New Project
(1) Project name
A) Writing the project name
(2) PLC Series
A) Selecting PLC series
(3) CPU kind
A) Selecting CPU kind
Creating New file for Rnet I/F module
or