LS ELECTRIC XGT Series - Read and Write of High-Speed Link

Chapter 5 High-speed Link Setting
5-11
5.4 Read and Write of High-speed Link
The screen is used for read/write of High-speed link’s parameter.
(Online menu → Read or Write)
Configuration
Description
1) High-speed link is available up to 12 for installed
Rnet I/F module.
- It can be used up to 12 with the other communication
module which use High-speed link.
2) It can read/write for each High-speed parameter.
- Check the box to set the High-speed link.
3) Read/Write of High-speed link parameter is not
affected to CPU’s Run mode.
If a High-speed link parameter is written to a CPU module, the CPU module saves the data. If CPU
module is exchanged, the High-speed link parameter has to backup from the CPU module. The
parameter has to re-write in exchanged CPU module.