LS ELECTRIC XGT Series - Page 42

Chapter 5 High-speed Link Setting
5-13
2) HS link
Screen configuration and description
Standard
information
Base no.
Base number of communication module which is connected with High-speed link.
Slot no.
Slot number of communication module which is connected with High-speed link.
Total HS
link
information
Run link
1: High-speed link parameters are communicate normally after power on.
0: High-speed link parameters are communicate abnormally after power on.
Link trouble
1: Error is occurred in slave station after Run link becomes normal status.
0: Error is not occurred in slave station after Run link becomes normal status.
Individual
HS link
information
Index
Serial number.
Station number
Slave module’s station number which is existed in network.
Module type
Module type which is used for setting up of high-speed parameter.
Data size
Data size of transmitting data from master module to slave module.
Read area
A device to transmit data from master to slave module.
Save area
A device to transmit data from slave to master module.
HsState
Display of communication status between master and slave module.
HsMode
RUN: Normal communication status between master and slave module.
STOP: Abnormal communication status between master and slave module.
HsTrx
Transmission/reception information between master and slave module.
HsError
Error is displayed while High-speed link data is processed.