LS Industrial Systems XGB Series - Setting Dedicated Service; Basic Parameter

Chapter 6 Dedicated Service
35
6.2 Setting Dedicated Service
6.2.1 Basic parameter
(1) Setting basic parameter in XG-PD
Open XG-PD. Then, select slot that installed XBL-EMTA on project window. Double-click the slot.
[Figure 6-3] Selecting basic parameter and setting communication module
Double-clicking shows ‘communication module setting window’. Select FEnet from communication modules, then click enter
key. Finally, it shows the window as below [Fig. 6-4] Setting FEnet .
[Figure 6-4] Setting basic parameter
Double-clicking FEnet shows the basic setting window as below [Fig.6-5].
Double-click
Select FEnet
Double-click