Chapter 9 Remote Communication Control
77
[Fig. 9-7] Direct remote 1 on PC
(1) Connecting type
(a) Select connecting type. [Fig. 9-7] shows the Enet connection without using RS-232C. Select Enet.
(2) Connection stage
(a) Decide remote 1 or remote 2 for the connection with PLC. In this case, select remote 1.
(3) IP address
(a) Record IP address of FEnet I/F module for connection.
(4) After(3), all steps are same as the steps of the case using RS-232C. Select enter at this status, select connection on
online menu.
To Next Page
Loading...